Clarity software tutorials

Installation and setup

Installation of Clarity software is a 3 step procedure. First the Clarity software is installed, followed by drivers and systems.

• Installation of Clarity software
• Device drivers from Knauer
• Preconfigured Clarity systems from Antec

When properly installed, the predefined systems from Antec appear on the Windows desktop with a shortcut. See example how to start Clarity from a shortcut.

Hands-on session 1

The first session is about editing device settings, creating a peak table, configuring calibration and setting up and running a sample queue.

Screen recordings:

• 1.1 Start Clarity and create a new method file
• 1.2 Change DECADE II parameters
• 1.3 Change autosampler settings
• 1.4 Change pump settings
• 1.5 Set run time and start trigger
• 1.6 Link calibration file to method
• 1.7 Optimize integration settings
• 1.8 Peak table and calibration parameters
• 1.9 Sequence file and starting an analysis

Hands-on session 2

Session 2 is about reprocessing data. In this tutorial lots of chromatograms are reprocessed batch-wise. The resulting summary table and chromatogram overlay is printed in a summary report.

Screen recordings:

• 2.1 Select project CASE2 and create a method
• 2.2 Optimize integration and save method
• 2.3 Check and reprocess calibration standards
• 2.4 Create new calibration file and peak table
• 2.5 Batch-wise reprocessing of chromatograms
• 2.6 Create summary table and report
  tutorial 2.2 - 2.6 are > 3 Mb and may take a minute to load.

Hands-on session 3

Session 3 explains how to build a new system from scratch.

Screen recordings:

• 3.1 Create a system, install devices